- Joined
- Jun 9, 2014
- Messages
- 37
- Reaction score
- 0
Hi,
I have been designing some 3D printed stuff for a while and have started to share this through Shapeways.
All of my prints are now verified by shapeways and prints out well.
The number one sale is my petal lens and that small lightweight lens will remove your propeller shadows and add more density to your videos. Revision 4 of this model is right up and it is more tight then the previous versions. I can't design it to be 100% tight due to the tolerance of 3D printing, so you may have to add a piece of office tape to the lens to make it tight and secure. The lens is lightweigt and stays below .7 gram. Printed in a lovely black mate elastic plastic, that removes any flares! Buy one extra as a spare!
http://shpws.me/v99W
The second and most important piece I am offering is the gimbal protector. Just put it between your landing skids and secure it with a lockingstripe, and of you go. This piece of juvel protects your gimbal in case of a crash.
http://shpws.me/vael
The third piece is the best. It is works 100% together with the gimbalprotector. It is a mounting plate for a GPS tracker. The tracker is namned TKSTAR and you dont have to pay any fees, just add a prepayed simcard. This tracker have saved me from one flyaway, and this is the mount to use! You can buy this tracker from ebay at a very low cost.
http://shpws.me/v8hG
If you are sneaky, the two last things can be found on thingiverse if you own a 3D printer of you self! Free to use for personal use!
Regards, Joakim
I have been designing some 3D printed stuff for a while and have started to share this through Shapeways.
All of my prints are now verified by shapeways and prints out well.
The number one sale is my petal lens and that small lightweight lens will remove your propeller shadows and add more density to your videos. Revision 4 of this model is right up and it is more tight then the previous versions. I can't design it to be 100% tight due to the tolerance of 3D printing, so you may have to add a piece of office tape to the lens to make it tight and secure. The lens is lightweigt and stays below .7 gram. Printed in a lovely black mate elastic plastic, that removes any flares! Buy one extra as a spare!
http://shpws.me/v99W
The second and most important piece I am offering is the gimbal protector. Just put it between your landing skids and secure it with a lockingstripe, and of you go. This piece of juvel protects your gimbal in case of a crash.
http://shpws.me/vael
The third piece is the best. It is works 100% together with the gimbalprotector. It is a mounting plate for a GPS tracker. The tracker is namned TKSTAR and you dont have to pay any fees, just add a prepayed simcard. This tracker have saved me from one flyaway, and this is the mount to use! You can buy this tracker from ebay at a very low cost.
http://shpws.me/v8hG
If you are sneaky, the two last things can be found on thingiverse if you own a 3D printer of you self! Free to use for personal use!
Regards, Joakim