I hooked up the F1 wires from the Naza to the S-OSD ,that controls the artificial horizon side to side
Next I did the same with F2 ,that controls The ascending and descending part of the horizon .i use the bottom pin of F2 for the gimbal tilt,I spliced into the bottom wire of F2 and attached it to the gimbal tilt pin . The tilt works but the horizon moves up or down also. Not a big issue.
The two connections where the GPS and LEd plug into are very loose, any movement on the GPS plug and the OSD reboots.
I'll need some hot glue or something to secure the connections before a test flight.
I ordered a FDTI usb connector ,for updates . I should be able to change from metric to imperial ,move and change things on the screen and calibrate the voltage,it's a little off.
The best part so far ,it's in english :mrgreen: