- Joined
- May 13, 2016
- Messages
- 44
- Reaction score
- 7
- Age
- 36
I managed to fix a binding noise I was getting on my p3 adv gimbal yaw arm. I loosened the set screw raised the arm in the middle of the shaft and turned the yaw motor shaft to ensure the set screw sits on the flat/D of the shaft.
So turn drone on, IMU cal, gimbal calibration. Now my camera yaw is off centre by a good few degree's. Is the something I can do to get my camera bask to centre point? Tilt is still perfectly level.
Help would be appreciated!
So turn drone on, IMU cal, gimbal calibration. Now my camera yaw is off centre by a good few degree's. Is the something I can do to get my camera bask to centre point? Tilt is still perfectly level.
Help would be appreciated!