D
Deleted member 120647
Guest
Very clean and cosmetically intact P3adv and controller etc.. Both turn on as per normal but the controller had a bluey green indicator LED which I though might be a an indication of a stuck or failed firmware updater. This proved correct, the firmware has been updated and it can now control a drone. However when a controller (working) and Go app are connected to the drone the motors will not start and an attempt to do so prompts an "esc error" notice in the Go app.
Aside from that and the point of this particular post is that I also feel a faint vibration from the drone, I suspect it would be audible as a hum but I am deaf so can't check.
Does anyone know what might be 'humming' ?
It's more from the central region of the drone than say the arms but I disconnected the gimbal assembly in case it was from one of the motors there and this had no effect.
Aside from that and the point of this particular post is that I also feel a faint vibration from the drone, I suspect it would be audible as a hum but I am deaf so can't check.
Does anyone know what might be 'humming' ?
It's more from the central region of the drone than say the arms but I disconnected the gimbal assembly in case it was from one of the motors there and this had no effect.
Last edited by a moderator: