So finally convinced the fiancee and pulled a trigger on a P3 Pro. Delivered today, charged up remote and battery and thats when all the issues started. Issue #1: Firmware Update Formatted the SD card, copied latest FW v1.8.80 and restarted the P3. Update failed...tried at least 10 times, still failed. Trying to upgrade to v1.7.006 doesn't work as well. Always fails. Finally gave up and went to the Controller, update fine though the app Issue #2: No Signal No matter what I do, lightbridge transmission to the table is a no go! Also appears the P3 was already on 1.8.80 because in the app menus i see this: App: 2.8.0 RC: 1.6.0 AC: 1.8.80 Hoping to take it out and do some flying today but not looking likely. Any help would be...well helpful!