I had to replace the body of my P4P and I am getting ESC errors on all 4 motors.
When I was putting it together I forgot to put the bottom shell back on before screwingnin the motors. I read somone else did this and it damaged the motors because the screws hit the copper coils. I also soldered the wires with a high wattage soldering iron, but my solder points are clean.
Is it more likely the errors are from the screws in going too deep in the motors or could I have messed up the boards?
Also are the motors all the same, just wired differently for CCW and CW? I'm looking at some replacement motors that don't specify either direction.
When I was putting it together I forgot to put the bottom shell back on before screwingnin the motors. I read somone else did this and it damaged the motors because the screws hit the copper coils. I also soldered the wires with a high wattage soldering iron, but my solder points are clean.
Is it more likely the errors are from the screws in going too deep in the motors or could I have messed up the boards?
Also are the motors all the same, just wired differently for CCW and CW? I'm looking at some replacement motors that don't specify either direction.