I have a 3 axis DYS gimbal on my Phantom1. I am trying to get the tilt function to work. The transformation of the TX knob is straightforward. People tell me that on the RX to run 2 wires from F2 port on the Naza but I don't know where they go to on the gimbal. Please no "black wire, red wire, grey " instruction, as there are no wires to speak of on the F2 port.
Also, is the any setup in the NAZA or DYS software to enable the function.
Cheers.
Also, is the any setup in the NAZA or DYS software to enable the function.
Cheers.