DJI Phantom Assistant

[kemosabe421]

Just got a Vision +. I ran the DJI Phantom Assistant on the copter to
update the firmware. No problems. I then tried to connect the Assistant
to the controller but the software does not connect to the controller.
Any suggestions?

Thanks,

Kemo

 

[msinger]

If using the RC Assistant, the USB cable must be connected to your remote. If using the Phantom Assistant, the USB cable must be connected to the Phantom (under the white flap on the opposite side of the battery) and the Phantom and remote must both be turned on.

 

[kemosabe421]

Gotcha. Thanks!