plugged my P2V in this morning. It came up saying there was an upgrade to the main controller firmware, to version 3.0. I didn't even think about it, hit upgrade. Upgraded fine, told me to power cycle. I did so, but then upon restarting my P2V it says mismatch and i need to upgrade my assistant software.
Every indication is it is upgraded, but I cannot go and calibrate anything. It appears normal, but I'm concerned what will happen if i attempt to fly it.
Any suggestions/input?
see below.
DJI PHANTOM 2 Firmware 3.0 has been released.
Please be aware that this firmware version limits aerial systems from flying above special areas such as airports. Click here for the complete list of the special areas. Updating your firmware signifies you fully acknowledge and accept this function. DJI accepts no liability or damage(s) or injuries incurred directly or indirectly from your refusal to update this firmware.
Please upgrade the main controller Firmware to v3.0 using the Assistant software v3.0.
Download the latest Assistant software: http://www.dji.com/download/phantom-2-downloads/
Important:
1、Make sure to reconfigure all parameters and recalibrate the Transmitter in the Assistant software after upgrading the firmware.
What’s new?
Firmware
1. Special areas restriction
2. Increased support Phantom 2 Vision Plus.
3. Compass data error notification
4. H3-2D and H3-3D support
l Software
1. Special areas restriction section
2. H3-2D and H3-3D support
Upgrade Notes
1. Upgrade the main controller and central board firmware to the latest version using PHANTOM 2 Assistant V3.0 otherwise there will be malfunction caused by version mismatch.
2. Upgrade iOSD mini, iOSD Mark II firmware to the latest version before using them with PHANTOM 2.
Every indication is it is upgraded, but I cannot go and calibrate anything. It appears normal, but I'm concerned what will happen if i attempt to fly it.
Any suggestions/input?
see below.
DJI PHANTOM 2 Firmware 3.0 has been released.
Please be aware that this firmware version limits aerial systems from flying above special areas such as airports. Click here for the complete list of the special areas. Updating your firmware signifies you fully acknowledge and accept this function. DJI accepts no liability or damage(s) or injuries incurred directly or indirectly from your refusal to update this firmware.
Please upgrade the main controller Firmware to v3.0 using the Assistant software v3.0.
Download the latest Assistant software: http://www.dji.com/download/phantom-2-downloads/
Important:
1、Make sure to reconfigure all parameters and recalibrate the Transmitter in the Assistant software after upgrading the firmware.
What’s new?
Firmware
1. Special areas restriction
2. Increased support Phantom 2 Vision Plus.
3. Compass data error notification
4. H3-2D and H3-3D support
l Software
1. Special areas restriction section
2. H3-2D and H3-3D support
Upgrade Notes
1. Upgrade the main controller and central board firmware to the latest version using PHANTOM 2 Assistant V3.0 otherwise there will be malfunction caused by version mismatch.
2. Upgrade iOSD mini, iOSD Mark II firmware to the latest version before using them with PHANTOM 2.