- Joined
- Nov 14, 2014
- Messages
- 21
- Reaction score
- 2
Hi all,
I just picked up my first UAV - DJI Phantom 2 Vision. I have it all set up and ready to go....however.
I had it working. Pull sticks down together and the props would fire up. I connected the unit to the USB on my computer, looked around at the settings a bit, calibrated the IMU and everything seemed fine. Props would fire up.
Then, and I am not sure if this is where the problem came in, I clicked the "Phantom" button and entered NAZA-M mode. I looked around, but didn't change anything. Then, I simply went back to "Phantom" mode. In doing so, I received a message asking if I wanted to "reset" or something like that.
Now, I cannot get my props to fire up. I have power to the unit as evidenced by green blinking lights. I have power to the controller as the power light is green. I checked to make sure the controller is synched to the UAV via the Windows application. I can "see" the controller moving under "Basic" > RC tab. I ran a calibration of the sticks and that seemed to end fine (all ended in the middle). The only funny thing is that running the X1 calibration doesn't seem to do anything.
I am very new to this, so I am really frustrated. I cannot imagine what I did to screw this up.
PLEASE HELP!
I just picked up my first UAV - DJI Phantom 2 Vision. I have it all set up and ready to go....however.
I had it working. Pull sticks down together and the props would fire up. I connected the unit to the USB on my computer, looked around at the settings a bit, calibrated the IMU and everything seemed fine. Props would fire up.
Then, and I am not sure if this is where the problem came in, I clicked the "Phantom" button and entered NAZA-M mode. I looked around, but didn't change anything. Then, I simply went back to "Phantom" mode. In doing so, I received a message asking if I wanted to "reset" or something like that.
Now, I cannot get my props to fire up. I have power to the unit as evidenced by green blinking lights. I have power to the controller as the power light is green. I checked to make sure the controller is synched to the UAV via the Windows application. I can "see" the controller moving under "Basic" > RC tab. I ran a calibration of the sticks and that seemed to end fine (all ended in the middle). The only funny thing is that running the X1 calibration doesn't seem to do anything.
I am very new to this, so I am really frustrated. I cannot imagine what I did to screw this up.
PLEASE HELP!