Hi guys,
I've downgraded my P2V+ from 3.04 to 1.08 but sincerely I did I cannot get into calibration mode. The remote works fine (can start the motor) but I didn't find a way to get into calibration mode.
I'm back to 3.04 for new until I get figure out why. Any of you have an idea why?
Thanks,
r0ot5
Sent from my SGH-I337M using Tapatalk
I've downgraded my P2V+ from 3.04 to 1.08 but sincerely I did I cannot get into calibration mode. The remote works fine (can start the motor) but I didn't find a way to get into calibration mode.
I'm back to 3.04 for new until I get figure out why. Any of you have an idea why?
Thanks,
r0ot5
Sent from my SGH-I337M using Tapatalk