- Joined
- Dec 29, 2013
- Messages
- 182
- Reaction score
- 0
Request for Peripheral Mounting and Cable Management ideas
1.) I had a P2V (not Plus+). On its 100th flight, it flew back to Shenzhen, China (I call this the DJI Diamond Anniversary phenomenon )
2.) I purchased a crashed P2V+ cheap on eBay (just the aircraft, no camera or gimbal, no controller, no WiFi repeater, no batteries, nothing)
3.) Fixed crashed P2V+
3a.) Repairs successful.
4.) Flies great!
Now I'm in the process of converting this P2V+ into a Phantom 2
Parts list (already acquired or on order):
1.) H3-3D Gimbal
2.) Anti-interference Reinforcement Board
3.) mini iOSD
3.) Boscam 400mW Video Transmitter
4.) FrSky Taranis X9D Remote Control TX/RX Combo
5.) FEELWORLD 8" FPV Monitor with Dual Receivers and/or SkyZone FPV Goggles
6 (Down the road.) Flytrex Live
The items listed above in THIS color are typically mounted under the battery bay.
Once I have all these pieces on hand, I will start the overhaul.
So, what I am looking for from the community at large, are suggestions for peripheral mounting and cable management ideas. Would those of you who use some or all of these peripheral items please post close-up photos of your setup? I've been searching for a third-party peripheral mounting solution, but thus far haven't really found anything that doesn't impede the insertion and removal of the "Smart Battery" cartridge.
Post your pictures please!
. . . and Thank you in advance :!:
1.) I had a P2V (not Plus+). On its 100th flight, it flew back to Shenzhen, China (I call this the DJI Diamond Anniversary phenomenon )
2.) I purchased a crashed P2V+ cheap on eBay (just the aircraft, no camera or gimbal, no controller, no WiFi repeater, no batteries, nothing)
3.) Fixed crashed P2V+
3a.) Repairs successful.
4.) Flies great!
Now I'm in the process of converting this P2V+ into a Phantom 2
Parts list (already acquired or on order):
1.) H3-3D Gimbal
2.) Anti-interference Reinforcement Board
3.) mini iOSD
3.) Boscam 400mW Video Transmitter
4.) FrSky Taranis X9D Remote Control TX/RX Combo
5.) FEELWORLD 8" FPV Monitor with Dual Receivers and/or SkyZone FPV Goggles
6 (Down the road.) Flytrex Live
The items listed above in THIS color are typically mounted under the battery bay.
Once I have all these pieces on hand, I will start the overhaul.
So, what I am looking for from the community at large, are suggestions for peripheral mounting and cable management ideas. Would those of you who use some or all of these peripheral items please post close-up photos of your setup? I've been searching for a third-party peripheral mounting solution, but thus far haven't really found anything that doesn't impede the insertion and removal of the "Smart Battery" cartridge.
Post your pictures please!
. . . and Thank you in advance :!: