Hi everyone,
I was charging my three Phantom-branded batteries on my BC20-4 Balance charger today. The first two charged no problem.
When I plugged the third battery in to the charger, connecting first the red/black leads, then the 3S port, then the power cord, the LEDs started a different sequence and the battery wouldn't charge.
The sequence:
1) All LEDs on
2) Cells Equailizer LEDs off/Charge Status LED on
3) Charge Status off/2S LED on
4) Charge Status on/2S off
4) Charge Status off/2S on
5) All LEDs off
Then the sequence repeats again. (Same sequence regardless of the 1A/2A/3A setting; other switch is in LiPo)
When I checked the manual, I see that a single flash means the battery is being balanced, but this is not a single flash.
And now regardless of which battery I connect, the light sequence is the same.
Help!
I was charging my three Phantom-branded batteries on my BC20-4 Balance charger today. The first two charged no problem.
When I plugged the third battery in to the charger, connecting first the red/black leads, then the 3S port, then the power cord, the LEDs started a different sequence and the battery wouldn't charge.
The sequence:
1) All LEDs on
2) Cells Equailizer LEDs off/Charge Status LED on
3) Charge Status off/2S LED on
4) Charge Status on/2S off
4) Charge Status off/2S on
5) All LEDs off
Then the sequence repeats again. (Same sequence regardless of the 1A/2A/3A setting; other switch is in LiPo)
When I checked the manual, I see that a single flash means the battery is being balanced, but this is not a single flash.
And now regardless of which battery I connect, the light sequence is the same.
Help!