Did my first 2 flights today with my p3a. A few weird things:
1) sometimes when I turn on, the DJI go app links to the aircraft but says "no signal" (no image from the camera), even though the remote appears connected to the aircraft. If I turn everything off and back on again, (sometimes multiple times), it comes good. Sometimes changing from photo to video mode seems to set this problem off.
2) On my 2nd flight of the day, as I was turning the aircraft on, the gimbal did its dance, but then went limp. I had done a gimbal calibration earlier. A few more goes of turning everything off and back on, and it seemed ok again. Was starting to think it was broken.
3) when I was landing, the altitude was listed as 7 metres, when in fact I was about 30 cm off the ground! the ultrasonic sonar sensor said 30cm. What has gone wrong here? I was on perfectly flat ground in the country.
Thanks if you can shed any light on these issues.
Sent from my iPhone using PhantomPilots mobile app
1) sometimes when I turn on, the DJI go app links to the aircraft but says "no signal" (no image from the camera), even though the remote appears connected to the aircraft. If I turn everything off and back on again, (sometimes multiple times), it comes good. Sometimes changing from photo to video mode seems to set this problem off.
2) On my 2nd flight of the day, as I was turning the aircraft on, the gimbal did its dance, but then went limp. I had done a gimbal calibration earlier. A few more goes of turning everything off and back on, and it seemed ok again. Was starting to think it was broken.
3) when I was landing, the altitude was listed as 7 metres, when in fact I was about 30 cm off the ground! the ultrasonic sonar sensor said 30cm. What has gone wrong here? I was on perfectly flat ground in the country.
Thanks if you can shed any light on these issues.
Sent from my iPhone using PhantomPilots mobile app