Recent content by Norcat

Thanks for the help, rebinding fixed it and its now flying again! Thats the trouble if you don’t fly them for a while you forget all the tips and tricks.

Not used my P3P for a few months so charged everything up and took it out. The aircraft wouldn’t connect, went through all the settings which had returned to zero? There was no signal on the HD graph and no camera feed or control. It said Gimbal disconnected in the systems check menu, however it...

Yes that was the first thing I did when it went awol, I tried 3 different cables and two different tablets. I have now found a DJI specialist about 2 hrs away who do free diagnostic checks, so I am taking it in next week so they can confirm where the fault is.

I have lost all data from the drone and camera, I can operate the motors and steer the gimbal and all the lights on the drone are green, and the leds blink slow green indicating ready to fly. But I have no communication with the drone, I tried another phone to eliminate my ipad and its the...

I am almost certain my GL3008 controller needs a new module, I see them on ebay but they have 2 more ports an extra USB and an HDMI, will this work on my controller which just has 2 ports?

I am still trying to fix my loss of telemetry and camera, as I mentioned in a previous thread I have a gray screen and can control the motors and gimbal, but it shows disconnected at the top of the screen and all the telemetry on signal strength, batteries camera menu etc is missing. It has...

I am leaning towards having to do a full update, or throw it at the wall! Just tried it again and I got a yellow warning ‘weak transmission signal’ then it shut down the App, I tried several times to restart the App but after 2 seconds it goes back to the DJIGO start page. Tried it with the sd...

As said in an earlier post my P3P along with many others it seems is having problems with the data channel, it just stopped sending any telemetry or camera images and says ‘Disconnected’. Then last night at a fellow Phantom pilots house it was up and running like normal. So I know the drone is...

If you have this firmware on your App will it run older firmware i.e. Tx 1.4.10 AC 1.5.80? If not is it possible to downgrade the App back to 2.7.0 as I have lost live feed from the camera since I must have inadvertently hit upgrade on my Ipad, unless DJI have sneaked in an upgrade as I have...

Just an update, I opened the transmitter but found no obvious faults. Next time I turned the drone on it came up with the camera working BUT, it closed the app down in less than 2 seconds! Every time I opened the app it shut me down immediately. So I suspect a software conflict, I have never...

Yes green lights on all 3, what is strange is I flew a month ago put it in its case and didn’t move it until I tried to use it yesterday. The only thing I can think of is the backpack fell about a foot and a half from the back seat to the ground when I was putting it in the car, but its an...

I tried all of these suggestions, restarted app, transmitter and a/c, the top of the screen shows all the normal icons but all of them show no data and it says a/c disconnected and the heading and speed info in the bottom left are also blank. There is nothing coming back from the drone, only...

Today I charged up my P3P which has worked perfectly on its original software from 3 yrs ago, however it wouldn’t connect with the transmitter. The motors and gimbal tilt all work but there is no HD data transmission, when I go into status it says everything is normal , but I have no a/c data...

All is working now, I was running the app in my lounge where my wfi router is situated I have often done when using the flight sim. I turned the wifi off and it immediately came on line, so went out and flew and all is well.

Fired up the drone today as I am meeting P 1 pilot to show him what a P3 can do and after the RC and AC connect it immediately shuts down the app, I don’t even have time to press any keys, I get the camera picture then I get dumped out of the app. Have tried restart on the Ipad and rc and ac...