yea everything else works great! And yea it took a good hit.... broke the yaw arm, and base cover. Where did you post the video getting the magnet off?
Thanks for your help Ted!
Thank you for the reply! I have noticed when I clip the gimbal base cover on to the circuit bored that is when it gets pulled to the left if I pop that off it spins freely and there is no issue. But as soon as i clip the cover on and tighten the 4 screws that is when it gets held over to the left
I crashed my p3p and broke the yaw arm, so I replaced the yaw arm. I followed a step by step youtube video on replacing it. After i got the camera and gimbal back on the drone and powered it up i noticed the camera is always looking to the side. I tried an IMU calibration and a gimbal...
Looking to buy a complete gimbal for my 3 pro. My drone lost signal and went into return home mode and clipped a tree. Which in return broke the gimbal. I have looked on DJI's website, but thought maybe I could find a used one a little cheaper. Thanks in advance everyone!
Thank you for the clarification sir! I dont want to go 3 miles away either, but i do some ag equipment pictures and some of the long fields i cant make it all the way down. I appreciate the help!
I am newer to the drones, but a p3p is advertised to fly 3 miles. i can only get mine to about 1900-2000ft before the remote starts to loose signal and the camera signal becomes weak. I have the antennas on the remote straight up, if i angle them out a little i loose signal faster. Im flying in...
I have with mine! I leave the props on and it fits just fine! Doesn't seem like to much pressure on the props/motors. I've been meaning to post a picture
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.