Recent content by ebones5

Is it possible to install a P2V+ WiFi module on a standard P2V?

Besides FPV function, what significance does the WiFi board have?

Hello, I am wondering if the H4-3D GoPro gimbal will work with th P2V. I have read it won't work with the P2V+ (different body and different internals), but I believe the P2V is very similar to the standard P2. I would like to do this because I have the famous no FPV issue, the FC200 is a bit...

I just tried it. No luck yet.

Yes I have, I then bound it to the camera and still no FPV. I've tried this twice with no results.

I have the same problem. I have 3 batteries and all of them look good in software. However, when flying, two of them fly for about 30 seconds, then they start to drop about 2 percent per second and flash critical battery warning. I land the drone then the lights flash system error. My third...

Yes I'm aware this problem has been threaded over and over again, but I don't have FPV on my P2V. It seems that if you had a P2V+ you could replace the WiFi module with a new one, but on the P2V the WiFi module is integrated into the camera I believe. I have tried reflashing with stock firmware...

No problem!!! When I have time (I don't know when, maybe this week maybe in a few weeks) I'll try and work on an improved version, plus I'll see if I can make a new autoexec.ash for the P2V. Happy Flying!

The purple bar is only present if you use the autoexec.ash file mentioned earlier in the thread and you select narrow POV. It does not occur on the wide POV at 1080P 30. I can't remember if I modified the 720P 60 bitrate, If I did, its somewhere around 20 Mbps. I can't remember, but somewhere I...

Here it is, be sure to rename and take your precautions while flashing, it did work on mine. I havent been able to compare it to the rest of my footage yet. A side note: my FPV currently does not work, so I don't know if it will affect that, it wasn't working before the flash however either...

I apologize for the double post, but it appears my image didn't load in the above post.

I have created a version of the firmware that works on the standard P2V. I will upload it if you are still interested. I modified the values for 1080P30 for 24 Mbps, but I did not edit the range multipliers so it will vary between 18-24 Mbps, depending on conditions. I have a problem with the...