The shell has never been open. I had not calibrated the X1. Re-calibrated everything. Now works, including gimbal (X1). Thanks you. I do have one remaining problem that has been a slight issue for ever.
The X1 movement is very fast/quick/small lever movement for large gimbal movement. The...
Thanks Jason & Max! I understand about the bind button on the bottom of my Phantom 2. I have done this but did not leave the controller on for the P2 calibration. Followed y our instructions. Does not make any difference. Still no control over the P2 or attached Gimbal, even though I am...
I am cross posting this in the general forum in hopes for a wider audience. I am unable to get my controller to have any input on my Phantom 2. Binds between controller and Phantom, but controls to not affect the Phantom period. Has always worked great up-to-now. The full message can be...
Been a while........
I have not flown for a little while. I have a Phantom 2 w/2x3 Gimbal, FPV & standard controller. Purchased as a package from B&H about 1 1/2 years ago. All flights have gone well over the period of ownership.
About a month ago my computer crashed from a bad hard drive...
Thanks! I do normally keep the batteries at 50% between flights. Just do not know if I have time to fully charge, then 1/2 discharge the two batteries before I leave. I figured it would be worse to just charge to 50% so I was toying with leaving them at the current 9% until I return and can...
Hi All,
I know that batteries are discussed much on this forum but there is one part of that equation that I cannot seen to find an answer for. What percentage of battery charge to leave the P2 battery after a deep discharge?
I have just completed my first deep discharge of my 2 P2 batteries...
Thanks Buk!
Have tried everything you have stated. Did not work. I would love to read what others have said but my searches on the forum have not produced any results. Guess I am not entering the correct key words....
Bruce
Hi,
Just joined. Received my Phantom 2. Not even off the ground yet. Having very basis issues. Seems like I see solutions to all the hard problems, but none to the simple start off questions. Either here or at DJI. Need help getting started. Sorry, as I am sure that these questions are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.