Hello All
I am new phantom vision plus owner. I crashed my phantom and now the gimbal wigs out everytime I turn it on. I have seen many people methods of fixing it but none of it seems to work. So far I have
1. Fixed the alignment of the shaft so that the D shaped notch is correct.
2. Superglued the shaft in place as it had become a bit loose.
3. updated the firmware to 3.08, did an advanced recaliberation.
All the ribbons, motors that are external seem seem to be intact. I have not opened it up to check out if there is any internal damage. The stand is a bit bent as shown in the pic? is this what is causing it? Although if i tilt it it does not seem to help the camera. Any suggestions would be helpful.
I am new phantom vision plus owner. I crashed my phantom and now the gimbal wigs out everytime I turn it on. I have seen many people methods of fixing it but none of it seems to work. So far I have
1. Fixed the alignment of the shaft so that the D shaped notch is correct.
2. Superglued the shaft in place as it had become a bit loose.
3. updated the firmware to 3.08, did an advanced recaliberation.
All the ribbons, motors that are external seem seem to be intact. I have not opened it up to check out if there is any internal damage. The stand is a bit bent as shown in the pic? is this what is causing it? Although if i tilt it it does not seem to help the camera. Any suggestions would be helpful.