Hello,
I am somewhat of a newbie and trying to trouble shoot a tech problem with my Phantom 4 Pro+ and hoping your expertise can help.
The aircraft was flying fine for awhile until a few days ago I powered it up and it and the image on the RC screen was very pixelated and broken up. RC indicated, “Warning for heavy wireless interference.”
I have powered the drone up outside my house before with no issues, but I live in an dense urban area so many possibilities could have contributed to the interference. I walked around - a few blocks distance in either direction of my home, and still the video transmission was very bad. I switched frequencies, adjusted my antennas appropriately, but still no luck.
At the same time I was also receiving firmware update messages as well. I decided to upgrade the firmware to V01.05.0600, and now I have very little video transmission signal. The image is worse than before -complete pixelated noise. When I playback a recored image, it is also complete pixelated noise.
I re-installed previous the firmware version V01.05.300, but that did not resolve the issue, So I installed the latest firmware again (V01.05.0600).
Also, when I try resetting the camera - it fails.
IMU is functioning normal according to the summary page that appears when powering on the RC, but I when I try to recalibrate, it cannot complete a full calibration. It cannot complete step 4 out 6. I let it run for 15+ minutes and it will not advance to the next step.
Here are the operating specs I am currently working with:
P4 Pro+
Firmware V01.05.0600
DJI GO 4 app V4.2.6
RC System Version 01.04.01.00
RC Model # GL300E with built in Android tablet
I'm not sure what to try next - any advice will be greatly appreciated. Thank you!
I am somewhat of a newbie and trying to trouble shoot a tech problem with my Phantom 4 Pro+ and hoping your expertise can help.
The aircraft was flying fine for awhile until a few days ago I powered it up and it and the image on the RC screen was very pixelated and broken up. RC indicated, “Warning for heavy wireless interference.”
I have powered the drone up outside my house before with no issues, but I live in an dense urban area so many possibilities could have contributed to the interference. I walked around - a few blocks distance in either direction of my home, and still the video transmission was very bad. I switched frequencies, adjusted my antennas appropriately, but still no luck.
At the same time I was also receiving firmware update messages as well. I decided to upgrade the firmware to V01.05.0600, and now I have very little video transmission signal. The image is worse than before -complete pixelated noise. When I playback a recored image, it is also complete pixelated noise.
I re-installed previous the firmware version V01.05.300, but that did not resolve the issue, So I installed the latest firmware again (V01.05.0600).
Also, when I try resetting the camera - it fails.
IMU is functioning normal according to the summary page that appears when powering on the RC, but I when I try to recalibrate, it cannot complete a full calibration. It cannot complete step 4 out 6. I let it run for 15+ minutes and it will not advance to the next step.
Here are the operating specs I am currently working with:
P4 Pro+
Firmware V01.05.0600
DJI GO 4 app V4.2.6
RC System Version 01.04.01.00
RC Model # GL300E with built in Android tablet
I'm not sure what to try next - any advice will be greatly appreciated. Thank you!
Last edited: