Hey J Dot, thanks for taking the time to help me out. Much appreciated!
As for the tx I'm using, it's the Futaba T8FG Super which is what comes stock with this edition of P2. And yes the DSLRpros rx has only one wire coming out of it as its an sbus so rather than have individual wires coming out of the rx going to each individual motor, there's only one coming out of the sbus port powering everything from there. (Hope I explained that correctly)
Thanks for the pic with directional arrows. That helped me immensely as I didn't know where that loose servo wire connected to. I knew it was one of the 2 locations you pointed out but wasn't sure which & didn't wanna plug anything up haphazardly & end up frying my board inadvertently....(or something) It answered the question of where that one wire connects to (blue arrow)....but I'm stumped when it comes to that red arrow. Your illustration seems to be suggesting that (if i follow the red arrow) then the one servo wire coming out of the rx should go directly to the 3 pins on the main board? Correct me if I'm wrong there. But if that's the case then how will the rx talk to the naza? I'm leaning towards that it's connected correctly because at the moment, the tx & p2 are able to communicate so that's a good thing. Barring all else, I'm thinking that the advice that you gave to BSullivan applies to me too & my problem is that there's something disconnected causing the red lights (?) Lol...idk. And I'm so early in my troubleshooting stages ( the p2 just arrived by mail yesterday) that I don't even know which assistant to download. I'm working on that now & will update once I've successfully tackled that minor detail. Hope the pics are detailed enough. In one picture, you'll see that the wire set coming out of x1 x2 & x3 are disconnected, but I just did that to give you a better view of whats going on underneath there & what wires are going where. I don't think there are any aftermarket components in there, but rather that's the way that DSLRpros pros put this p2 together. And you're absolutely correct....there's virtually NO support for this version of the DJI phantom!