Hey guys,
I'm trying to resurrect my P2 Vision. Bought and installed a Taco 3D Power 2-D gimbal.
I have the gimbal nicely calibrated (which I thought would be the major issue... but turned out pretty easy)
Problem is, when connected through the gimbal, no power is getting to the camera. Fan doesn't turn on. Power LED is off. No WiFi. etc. If I connect directly to the camera, it powers up fine.
Anyone else have this issue? Fix?
Since the gimbal is obviously getting power (it levels quite nicely), I'm guessing it's the 2.5mm jack cable from the gimbal? Or Is there a board I need to be looking at? If I were to try to test the 2.5mm plug with a multimeter, what would I be looking for (volts on which collars)?
Thanks!
-C
I'm trying to resurrect my P2 Vision. Bought and installed a Taco 3D Power 2-D gimbal.
I have the gimbal nicely calibrated (which I thought would be the major issue... but turned out pretty easy)
Problem is, when connected through the gimbal, no power is getting to the camera. Fan doesn't turn on. Power LED is off. No WiFi. etc. If I connect directly to the camera, it powers up fine.
Anyone else have this issue? Fix?
Since the gimbal is obviously getting power (it levels quite nicely), I'm guessing it's the 2.5mm jack cable from the gimbal? Or Is there a board I need to be looking at? If I were to try to test the 2.5mm plug with a multimeter, what would I be looking for (volts on which collars)?
Thanks!
-C