I have Phantom 1 with H3-2D gimbal with DJ6 2.4 HZ TX. I turned on the tx then the Phantom and the camera immediately pointed down. It would only point straight when I turned off tx. I connected tx to pc and ran the RC ASSISTANT. I downloaded the latest firmware 1.0.2.26 and now when I turn on the tx it lights green 3 beeps and turns to what seems yellow and now motors wont start. I scoured this forum and used all the helpful info to no avail. i followed the binding instruction that seem to be the proper ones
1. Plug in battery with battery out of quad, the light will come on solid red on the receiver in the battery compartment.
2. Turn on DJ6. The led in the battery compartment will begin to blink green.
3. Hold down (or up really) press the button next to the led on the receiver until the light blinks red once or twice, 2 or 3 seconds, then let go.
During step 2 the led in batt compartment actually turns off never green. I calibrated the tx according to manual, in naza assistant and rc assistant numerous times to no avail. Receiver type set to d-bus and tx set to mode 2. Did advanced imu calibration and upgraded firmware on tx numerous times. The x1 tilt moves all the way facing down and when turn pot to center position with screwdriver will face up towards blades not straight. Naza assist says there is a latest update to 4.04 using naza assist version 2.4. Im on 4.02 naza assist version 2.20. I am fearful to do update as it might cause more issues..Any help is greatly appreciated. Thank you
1. Plug in battery with battery out of quad, the light will come on solid red on the receiver in the battery compartment.
2. Turn on DJ6. The led in the battery compartment will begin to blink green.
3. Hold down (or up really) press the button next to the led on the receiver until the light blinks red once or twice, 2 or 3 seconds, then let go.
During step 2 the led in batt compartment actually turns off never green. I calibrated the tx according to manual, in naza assistant and rc assistant numerous times to no avail. Receiver type set to d-bus and tx set to mode 2. Did advanced imu calibration and upgraded firmware on tx numerous times. The x1 tilt moves all the way facing down and when turn pot to center position with screwdriver will face up towards blades not straight. Naza assist says there is a latest update to 4.04 using naza assist version 2.4. Im on 4.02 naza assist version 2.20. I am fearful to do update as it might cause more issues..Any help is greatly appreciated. Thank you