I had to replace the yaw arm. Got everything apart and the piece replaced, but during reassembly I’ve run into a weird problem. I can’t get the screws to start in the backing plate.
Two are slightly bigger and start no problem. The remaining three seem too large for the holes. I’m certain I didn’t mix up these for different screws in the assembly, but they won’t go in. Am I losing my mind, or have others had the same issue?
Dave
Two are slightly bigger and start no problem. The remaining three seem too large for the holes. I’m certain I didn’t mix up these for different screws in the assembly, but they won’t go in. Am I losing my mind, or have others had the same issue?
Dave