Hello everyone,
For several weeks I have been trying to make it work the pitch control of my Tarot 2d gimbal through the NAZA-M F2 slot and X1 nob(channel 7) of the transmitter (RC). I updated the firmware to the last dji have released but the x1 does not move even in calibration mode. The last thing I did trying to make it work (where I think I made a brutal mistake) was that I upgraded the transmitter with Phantom 2 RC Assitant Software v.1.01.19. Now the transmitter when I power cycle, the LED turns green and then red accompanied by a beep (buzzer) and then the LED goes out. Now, none of the assistant assistant or the phantom recognizes. How to fix it? My Phantom is the first generation with none modification.
Help please!
For several weeks I have been trying to make it work the pitch control of my Tarot 2d gimbal through the NAZA-M F2 slot and X1 nob(channel 7) of the transmitter (RC). I updated the firmware to the last dji have released but the x1 does not move even in calibration mode. The last thing I did trying to make it work (where I think I made a brutal mistake) was that I upgraded the transmitter with Phantom 2 RC Assitant Software v.1.01.19. Now the transmitter when I power cycle, the LED turns green and then red accompanied by a beep (buzzer) and then the LED goes out. Now, none of the assistant assistant or the phantom recognizes. How to fix it? My Phantom is the first generation with none modification.
Help please!