- Joined
- Jan 3, 2014
- Messages
- 3
- Reaction score
- 0
Dear all,
I just bought Phantom 2 Vision for about 2 weeks. Flight practices within these 2 weeks were good except a fly away when I took it off near transmission tower. After simple repairs, the Phantom 2 Vision was normal again and it flew nicely for a day or two.
Then yesterday when I tried to calibrate the compass, I could get constant yellow LED after toggling S1 switch by about 20 - 30 times. I rotated it 360 degree horizontally to get constant green LED. But I could not get slow flashing green LED when I uprighted the Vision (nose downward) and turn it 360 degree.
Today I connect the Vision to computer by Assistant Software. Get error 27 requiring me to calibrate compass. I use a strong magnet around the leg with 5-wire and metal case at the bottom, and could turn X axis of compass to positive value. The error 27 message is gone.
However, I could not get into compass calibration mode at all. When I switch the S1 switch over 100 times, the LEDs are still slow flashing yellow. It could never turn into a constant yellow.
All other features appear to be normal. I change to new batteries for RC controller, charge the wifi extender and place a newly charged battery to Vision. Still no improvement.
The bind parameters shown in the Apps on my Samsung Note 2 appear to be normal. The camera icon in the apps could be used normally.
Any suggestion as to what is the problem with my S1 switch on the RC ? or anything wrong with the compass calibration ?
Raymond
I just bought Phantom 2 Vision for about 2 weeks. Flight practices within these 2 weeks were good except a fly away when I took it off near transmission tower. After simple repairs, the Phantom 2 Vision was normal again and it flew nicely for a day or two.
Then yesterday when I tried to calibrate the compass, I could get constant yellow LED after toggling S1 switch by about 20 - 30 times. I rotated it 360 degree horizontally to get constant green LED. But I could not get slow flashing green LED when I uprighted the Vision (nose downward) and turn it 360 degree.
Today I connect the Vision to computer by Assistant Software. Get error 27 requiring me to calibrate compass. I use a strong magnet around the leg with 5-wire and metal case at the bottom, and could turn X axis of compass to positive value. The error 27 message is gone.
However, I could not get into compass calibration mode at all. When I switch the S1 switch over 100 times, the LEDs are still slow flashing yellow. It could never turn into a constant yellow.
All other features appear to be normal. I change to new batteries for RC controller, charge the wifi extender and place a newly charged battery to Vision. Still no improvement.
The bind parameters shown in the Apps on my Samsung Note 2 appear to be normal. The camera icon in the apps could be used normally.
Any suggestion as to what is the problem with my S1 switch on the RC ? or anything wrong with the compass calibration ?
Raymond