Hi Guys, new here...If only I knew about this place before yesterday ;o)
So I made the infamous mistake of using the prop guard screws without the guards, all 4 motors are shot. So I ordered T-Motor antiGravity! MN2214 V3.0 because they seemed to be popular on youtube. 1. are these a good choice? 2. Will they work with the existing ESC? 3. How do I know if I fried my ESC as well as the motors? 4. Will the original props that came with my FC40 work on these or will I need to buy props that are not self tightening? (I am also going to buy new props any suggestions?)
Thank you in advance! I removed the prop guards because I just installed one of the cheap Chinese gimbals for a go pro and I was thinking I needed to get her as light as possible. Took her out for a flight test after putting her back together and just jerky prop movement. ;o(
So I made the infamous mistake of using the prop guard screws without the guards, all 4 motors are shot. So I ordered T-Motor antiGravity! MN2214 V3.0 because they seemed to be popular on youtube. 1. are these a good choice? 2. Will they work with the existing ESC? 3. How do I know if I fried my ESC as well as the motors? 4. Will the original props that came with my FC40 work on these or will I need to buy props that are not self tightening? (I am also going to buy new props any suggestions?)
Thank you in advance! I removed the prop guards because I just installed one of the cheap Chinese gimbals for a go pro and I was thinking I needed to get her as light as possible. Took her out for a flight test after putting her back together and just jerky prop movement. ;o(