My drone when its only a few feet away here in my shop or out at the park where i flew just yesterday..the tablets screen shows the telemetry battery and what mode im flying with the GPS and cameras settings and the cameras picture then i get No telemetry and right upper and left upper of the tablets screen two N/As..the tablets screen then shows a black and white image that dont move
Like the transmitter/ gimbal has no power......the drone still controls ok....with it not running the props here in the shop..the telemetry is off and on
Could this be so simple as un plugging the gray ribbon out of the top of the gimbal and plugging it back in as in a loose connection their.
Any helpful ideas are very appreciated Thank you.
Like the transmitter/ gimbal has no power......the drone still controls ok....with it not running the props here in the shop..the telemetry is off and on
Could this be so simple as un plugging the gray ribbon out of the top of the gimbal and plugging it back in as in a loose connection their.
Any helpful ideas are very appreciated Thank you.
Last edited: