My gimbal not work after updating

[ydavicosta]

Hello, my phantom vision plus 2 after updating the Zen Imu (1.0.0.6) the gimbal just stopped working. Only is emitting a intermittent horn.

Already updated all updates available several times and the problem persists.

Calibrated several times and the gimbal does not respond.

I would like a response on how to solve this problem, as seen several cases reported in international forums but so far no solution.

Thanks in advance!


Davi Costa

 

[ydavicosta]

Re: My gimbal is dead after updating

Please, any ideas?

I really need help! It´s terrible!

 

[burlbark]

Re: My gimbal is dead after updating

Have you done an advanced calibration after deleting all BTU's? You are not the first to report this. There is a good dozen now that have experienced this. Some have had success deleting the Assistant off their PC and downloading the newest version then updating again.

 

[ydavicosta]

Re: My gimbal is dead after updating

So, I did this same times. But the problem continue!
I used all version oh the assistent of DJI...1.8/2.0/3.0/3.2...

Meaby a reset the gimbal but I don't do this.

Already send email to ver but no answer!

 

[ydavicosta]

How is posslible delete all BTu´s?

 

[ydavicosta]

Somebody have any idea?

 

[ydavicosta]

Until now, nothing!