Hi all, crashed my P3 Advanced and have since replaced the broken roll and yaw arm, along with the ribbon cable. I currently have no gimbal movement on startup or otherwise and the video output is a garbled mess (picture included). I ensured all the cables where in tightly and am suspecting the aftermarket ribbon cable is the cause. I am wondering, if replacing the ribbon cable doesn't solve my issue, how do I continue with the repair, short of buying a whole new camera and gimbal setup? That is, how can I diagnose if I have a bad board somewhere? I hate to just keep buying parts trying to solve the issue.
I've got about $60 into the repair so far, and am hesitant to spend more money if I need to replace the setup (and not sure if the individual boards are even available to purchase).
Any insight or tips would be greatly appreciated.
Thanks,
Mark
I've got about $60 into the repair so far, and am hesitant to spend more money if I need to replace the setup (and not sure if the individual boards are even available to purchase).
Any insight or tips would be greatly appreciated.
Thanks,
Mark