- Joined
- Jul 27, 2015
- Messages
- 947
- Reaction score
- 431
OK so checked the numbering on the new ribbon cable and it matches my other P3's so guess they just don't seal the top with the black DJI cardboard top like other parts.
Anyways, I replaced all cables using the part42 cable set with the exception of the usb connector and the 2 wire set that goes to the battery plug. Reseated all gimbal connections and NO DICE. I also notice the red/green indicator light on the camera does not light up at all. I read the other threads about FW 1.9.60 possibly frying camera boards and I'm wondering if that's what happened here. Like I said, this was an ebay P3 that was crashed and user claims it did not go down in water and I found no evidence of that. I think this camera board is fried. I even tried putting and SD with FW 1.08.0080 and no luck.
Anyways, I replaced all cables using the part42 cable set with the exception of the usb connector and the 2 wire set that goes to the battery plug. Reseated all gimbal connections and NO DICE. I also notice the red/green indicator light on the camera does not light up at all. I read the other threads about FW 1.9.60 possibly frying camera boards and I'm wondering if that's what happened here. Like I said, this was an ebay P3 that was crashed and user claims it did not go down in water and I found no evidence of that. I think this camera board is fried. I even tried putting and SD with FW 1.08.0080 and no luck.