Hi guys,
I'm new here !
The plot is as follows, - bought a Phantom 2 w/ Zenmuse H3-3D - had a GoPro Hero 3 White Installed everything as per the instructions, first maiden flight was ok. Now, when I fly, my gimball is going crazy. I take off, fly for a few minutes and then it goes to jello and afterwards it just twerks without any logic. Sometimes I can recover it by messing with the tilt, sometimes not. Will post video soon. Ideas ? Will soon change all the dampeners, I switched to 50* black on the two holes that don't have safety pins, still to no avail. Yes, it's upgraded.
What's that thing about facing north ?
Recalibrating the compass should do anything ?
Also, when starting up, the gimball hits the ground slightly, when it's doing it's axis thingy, should I hold it in my hand while starting for it not to touch anything while doing the axis thingy ?
[youtube]https://www.youtube.com/watch?v=LBUPnOeHhUA[/youtube]Example clip shot today. Gone to jello after multiple minutes, after which by adjusting tilt I managed to get it to work again.
I just went out again after doing a compass recalibration, and in 10 minutes of flying it happened only once. Weird thing though, the twerking doesn't start when you jerk around the controllers, moving it aggressively from left to right, and forward to back, but when you fly forward - not with much speed. At a highspeed run I had no problems, the problem occured when I was gently going forward. It's kinda scary that I'm the only one that has encountered this issue.
After examining the video, I could see that there isn't any jello now before the twerking starts, but the gimball drops down and then begins twerking.
I'm new here !
The plot is as follows, - bought a Phantom 2 w/ Zenmuse H3-3D - had a GoPro Hero 3 White Installed everything as per the instructions, first maiden flight was ok. Now, when I fly, my gimball is going crazy. I take off, fly for a few minutes and then it goes to jello and afterwards it just twerks without any logic. Sometimes I can recover it by messing with the tilt, sometimes not. Will post video soon. Ideas ? Will soon change all the dampeners, I switched to 50* black on the two holes that don't have safety pins, still to no avail. Yes, it's upgraded.
What's that thing about facing north ?
Recalibrating the compass should do anything ?
Also, when starting up, the gimball hits the ground slightly, when it's doing it's axis thingy, should I hold it in my hand while starting for it not to touch anything while doing the axis thingy ?
[youtube]https://www.youtube.com/watch?v=LBUPnOeHhUA[/youtube]Example clip shot today. Gone to jello after multiple minutes, after which by adjusting tilt I managed to get it to work again.
I just went out again after doing a compass recalibration, and in 10 minutes of flying it happened only once. Weird thing though, the twerking doesn't start when you jerk around the controllers, moving it aggressively from left to right, and forward to back, but when you fly forward - not with much speed. At a highspeed run I had no problems, the problem occured when I was gently going forward. It's kinda scary that I'm the only one that has encountered this issue.
After examining the video, I could see that there isn't any jello now before the twerking starts, but the gimball drops down and then begins twerking.