Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

H3-3D spare part needed

Discussion in 'Zenmuse H3-3D/H4-3D GoPro Gimbal' started by PeterPan, Aug 13, 2014.

  1. PeterPan

    Joined:
    May 25, 2014
    Messages:
    11
    Likes Received:
    0
    Hello Phantom pilots!

    Last week my worst nightmare came out. My phantom ditched into the water. Luckily for me it was some clean mountain water and I managed to get everything working again (even my GoPro). During the crash I damaged my H3-3D gimbal slightly on a very unfortunate point. It is the point were the flat cable goes into the pitch motor. The flat (imu cable I believe) is cutted by a sharp rock.... (see attached picture)

    My question to you is:

    - Is this the end of my H3-3D?
    - Or do you maybe know an adres to get a spare cable?

    Thanks a lot!!!!
     

    Attached Files:

  2. nintendrone64

    Joined:
    Feb 19, 2014
    Messages:
    353
    Likes Received:
    2
    Location:
    Simi Valley, CA
  3. Fyod

    Joined:
    May 21, 2014
    Messages:
    684
    Likes Received:
    61
    Location:
    Central EU
    Why is it designed so vulnerably?
    I'm going to have to make some kind of protection for it.