I setup my gl-2x and did the wobble test.
that checks out
I connected the middle wire to the bottom of the naza F2 port.
Then I installed the appropriate basecam drivers so I can attach the gimbal to my computer and configure it. I went into RC settings and enabled channel 7 (i think thats right)
Naza already has gimbal enabled and X1 calibrated from my last gimbal.
I cant seem to get any response in pitch from the gl-2x.
It doesnt work from the controller and doesnt seem to work when I adjust the min/max in the naza.
Am I missing something in the basecam software?
that checks out
I connected the middle wire to the bottom of the naza F2 port.
Then I installed the appropriate basecam drivers so I can attach the gimbal to my computer and configure it. I went into RC settings and enabled channel 7 (i think thats right)
Naza already has gimbal enabled and X1 calibrated from my last gimbal.
I cant seem to get any response in pitch from the gl-2x.
It doesnt work from the controller and doesnt seem to work when I adjust the min/max in the naza.
Am I missing something in the basecam software?