Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Gimbol dead

Discussion in 'Zenmuse H3-2D GoPro Gimbal' started by Patrik Olson, Apr 9, 2015.

  1. Patrik Olson

    Joined:
    Apr 7, 2015
    Messages:
    2
    Likes Received:
    0
    Hello all P2 flyers!

    I have some problem with my gimbol H3-3D unit.
    It is dead after an update of firmware.

    I have tried to re-set the unit by short cutting the connection points as showned in severel videos on youtube.
    - I have been very focused on really connect correctly to make the short cut.

    Do anyone have a tip on how to get my gimbol back to life?

    Most appriciated for any help in this matter.

    Regards,
    Patrik
     
  2. kilos1

    Joined:
    Apr 8, 2015
    Messages:
    19
    Likes Received:
    0
    i had a problem like that, with the gimbol. when i turn the drone the gimbol did come to life and went to center. but when i moved the gimbol to point down, it went but will not come back up.
    after talking to dji, i connect the drone to the computer and went back to the calibrate screen, and that help the problem. so if you did not re-calibrate the gimbol try that.
    hope that helped
     
  3. Patrik Olson

    Joined:
    Apr 7, 2015
    Messages:
    2
    Likes Received:
    0
    Thanks kilo1
    I will ry to calibrate it and see what happens.
     
  4. Marlin009

    Joined:
    Dec 31, 2014
    Messages:
    1,091
    Likes Received:
    515
    Location:
    West Coast of Florida
    I had a dead gimbal after an update too. It no longer showed up in the assistant. This is the video I followed to reset it. I used a paper clip. Took two tries.