- Joined
- Apr 19, 2014
- Messages
- 26
- Reaction score
- 0
I updated my firmware to 3.0 and was unable to properly calibrate the gimbal tilt. When I move the lever back and forth during calibration, the first time I move it it will show the full value range on screen, but then jumps to being stuck at zero. If I move the lever a lot sometimes it will jump a tiny bit, but only enough to tilt the camera up a few degrees and only for a split second.
I tried downgrading to 2.0 but nothing changed...
Anyone had this happen? I may go back to 1.8 and see if that helps... with 1.8 was the only time my Phantom was %100 functional
EDIT: when I search for gimbal calibration, both word get left out of the search because they are "too common"... that is not helpful at all
I tried downgrading to 2.0 but nothing changed...
Anyone had this happen? I may go back to 1.8 and see if that helps... with 1.8 was the only time my Phantom was %100 functional
EDIT: when I search for gimbal calibration, both word get left out of the search because they are "too common"... that is not helpful at all