So, just had my first flight with the 3.0 Go update, iphone 6s Plus running ios10.0.2 My P3S is on firmware 1.6.8
Up until now I have had no issues with previous updates, I naively just accept updates when the request pops up.
After reading all the posts that dire prognostications would befall me for even contemplating a flight with that firmware/Go combination it was with rapidly beating heart that I set off down the road to my safest flying area.
The sad news, sorry guys is that I have no issues of note to report.
Only went downrange around 830ft, had one loss of signal for trees which cleared once I went a smidge higher. I would have flown further but my fingers were turning blue, its chilly and damp today.
Altitude, I then went up around the same, 830ft or so and again no problems apart from a loss of signal because she was overhead and my antenna was too vertical, quickly fixed.
Flicking between stills and video was instantaneous.
Up until now I have had no issues with previous updates, I naively just accept updates when the request pops up.
After reading all the posts that dire prognostications would befall me for even contemplating a flight with that firmware/Go combination it was with rapidly beating heart that I set off down the road to my safest flying area.
The sad news, sorry guys is that I have no issues of note to report.
Only went downrange around 830ft, had one loss of signal for trees which cleared once I went a smidge higher. I would have flown further but my fingers were turning blue, its chilly and damp today.
Altitude, I then went up around the same, 830ft or so and again no problems apart from a loss of signal because she was overhead and my antenna was too vertical, quickly fixed.
Flicking between stills and video was instantaneous.