I was trying to run a pre-programmed waypoint path via Litchi with my P3S today. The path loaded, but I got the following error when trying to run it:
"Failed to upload mission. (Reason: the damping check is failed)"
Has any else had this issue? My gut is telling me that 'damping' is likely relating to position correction capability. It was fairly windy today, so it may have measured the correction that it was needing to do, and found that it could not execute the flight route at the specified speed while correcting for the wind. Does that sound right? I have contacted Litchi's customer service group to get their thoughts, but I'm open to anyone's thoughts on the matter.
Thanks.
"Failed to upload mission. (Reason: the damping check is failed)"
Has any else had this issue? My gut is telling me that 'damping' is likely relating to position correction capability. It was fairly windy today, so it may have measured the correction that it was needing to do, and found that it could not execute the flight route at the specified speed while correcting for the wind. Does that sound right? I have contacted Litchi's customer service group to get their thoughts, but I'm open to anyone's thoughts on the matter.
Thanks.