I created this piece in less than an hour using Lexan Polycarbonate @ .093" thick.
It fits the groove in the Phantom struts perfectly........using a sheet of paper and the camera pointed down at 90 degrees I marked the FOV and created a piece with maximum protection without obstructing the camera view.
I cut holes in the piece to reduce the weight.
I do not have a small scale, but it likely does not weigh but a few ounces.
It is held tightly in place with 4 small zip ties and has very little flex.......
It fits the groove in the Phantom struts perfectly........using a sheet of paper and the camera pointed down at 90 degrees I marked the FOV and created a piece with maximum protection without obstructing the camera view.
I cut holes in the piece to reduce the weight.
I do not have a small scale, but it likely does not weigh but a few ounces.
It is held tightly in place with 4 small zip ties and has very little flex.......