S I picked up a dual batt tray system from 1RC, the flat "wing" deals on the sides. But I didn't like it. Batts stuck out too far and I could not use my case, I wanted a tighter, cleaner solution that would fit in the case without having to pull it off. I think I nailed it.
I cut the mounting tabs a bit and mounted them high on the outside of the landing gear vertically. Couple of cuts and four rivets and its super slick. Check out the photos.
https://www.dropbox.com/sc/51juh40bai3uipy/o2rNuM66QV
By the way, w/o go pro, got a solid 13 minutes of just night flying around my front yard. Power was good too, lots of lift. I'm very happy with it. :mrgreen:
I cut the mounting tabs a bit and mounted them high on the outside of the landing gear vertically. Couple of cuts and four rivets and its super slick. Check out the photos.
https://www.dropbox.com/sc/51juh40bai3uipy/o2rNuM66QV
By the way, w/o go pro, got a solid 13 minutes of just night flying around my front yard. Power was good too, lots of lift. I'm very happy with it. :mrgreen: