Hi guys. Have been enjoying the forum since the Mrs. figured I was a good boy and bought me a P3/Std for Valentines.I have about 5 hours flight time, with 1 crash, ( forgot to get out from under the pine tree when I hit the RTH ) . I learned a lot so far, from all the people here, so I figured it was time to get on board,. My issue at the moment is a non functioning motor. Trying out the bird on a new tablet, with GO app installed, I had it hovering about a foot off the ground when it took a sharp right into the dirt. No scratches, not even a broken propellor. Figured it was time to update the FW, and Go app, as I was having problems with it. Now, after going through the FW problem, of the constant, beeping and taking forever to load, everything updated, and we are ready to fly!. One problem. Rear CW motor will not spin. I'm suspecting it failed while hovering, and caused it yaw right. As I should be within the warranty period, what would be the best course of action, when dealing with DJI ? I'm fairly proficient with a soldering iron, and not afraid to open it up. But as it's still almost new. I would like to get the opinion of the more knowledgeable folks here. Any and all replies are greatly appreciated. Glad to be a member.