Hello Pilots,
I have just received my gimbal after a warranty repair by DJI tecnhologies. They´ve changed yaw motor, yaw esc and a ribbon cable. They say they upgraded, calibrated and tested the gimbal for functionalty. Now that I connect it to the phantom it simply does not powers on, no leds on neither. I have checked the connections and they are correct. I know there are others thread on this, but in my case the gimbal does not power on so the pin bridge can´t be done, the software does not recognize the gimbal neither. I have also tried to connect the gimbal directly without the interferance board with no results.
Any suggestions or tricks will be more than welcome.
I have just received my gimbal after a warranty repair by DJI tecnhologies. They´ve changed yaw motor, yaw esc and a ribbon cable. They say they upgraded, calibrated and tested the gimbal for functionalty. Now that I connect it to the phantom it simply does not powers on, no leds on neither. I have checked the connections and they are correct. I know there are others thread on this, but in my case the gimbal does not power on so the pin bridge can´t be done, the software does not recognize the gimbal neither. I have also tried to connect the gimbal directly without the interferance board with no results.
Any suggestions or tricks will be more than welcome.
Last edited: