Recent content by xilla

Almost certain they would fit. Don't own one personally, but there are at least a few people on here that have replaced ARGtek's panels with Alfas. They are the same connector (RP-SMA) as any of the antennas that came with the ARGtek.

In advance, I'm not an expert. They look like they are the ones you need. More specifically, you need a U.FL to RP-SMA female pigtail antenna cable. That is a cable with a U.FL connection on one side and an RP-SMA female (threads outside, pin inside) connection on the other. In my searches I...

So do I, but if I could afford one, I would have probably bought an inspire lol. I found a lot of expensive options online, a few had like £40 min order cost, but then I found 3D Hubs: Browse online 3D printing services They seem to have a lot of options for local printers. Price is highly...

Appreciate your input. This is why it's worth having a second pair of eyes. On closer inspection, that distance was 8.2cm, not the 9 I intended. Whoops. It's 9.5cm now. Fingers crossed I didn't fudge any other measurements lol. I'll get this printed and uploaded to thingiverse tomorrow in case...

Yeah, I was a little concerned about that distance. I left it as is (9cm) because the m25 is 9cm wide and the m04 is 6.6cm wide (according to Alfa website). 4.5+3.3= 8.8cm. I will increase it though. Other than that, does it appear a viable design?

Hello Pilots! TL;DR: If someone has a 3D design for an antenna mount for P3S, please share as I'm sure it's much better than mine. Otherwise rate my antenna mount please. I've been having fun reading through the posts on this forum, been learning a lot. I wanted to do an antenna upgrade for...