I am running a turnigy radio with dragon link and need to set it up so that in the off position or lost signal position it goes to failsafe. right now it is set to go to atti. I can see in assistant that when I turn off the tx it goes to atti, but dont know how to change it to failsafe.
Im getting somewhere now.
Just went back into assistant and noticed that the "control mode" block shows the to be in fail safe when tx is off, but the black slider is under the atti block and on the bottom of the screen it says that it is in atti mode, not failsafe. So...how to I get it to go...
ok, so I just did the most recent update and re calibrated tx and compass. failsafe is set at RTH. According to nazza assist when the tx is turned off it goes into failsafe. just took a test flight, turned off tx mid flight and the phantom flys away. went back into assistant and changed my...
I thought a home location was set every time the machine was plugged in/turned on?
If not then what is the procedure to set a home location.
BTW...when it goes into failsafe the led blinks yellow...
Got the dragon link system setup on the phantom. But when I put into fail safe it does not return home....actually flys away until I take it out of fail safe. No red lights so it has good gps signal. Any ideas?
After the light starts flashing red, then what happens....every time it has gone red I have plenty of time to land as long as I am close. I was flying fpv tonight and couldnt see the light flashing red when the battery was going dead. Luckily I was landing when the phantom began to come down...
what happens if I need to use the rth feature and the 60' climb does not keep me out of harms way? Can the 60' be reprogrammed to a higher value?
Also...say I am flying a t 200', will it drop down to 60' then come to me or stay at 200'?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.