Here's the video of my P2V+
Yes. It's blinking yellow back light and solid red in front when i start the arm.
And here's the MOD value looks normal for me.
Finally i can start my P2V+ motor!!!
Problem solved!! So happy!!! :D
I open up the top housing and the ceramic antenna it's actually loose. Plug it in and my motor can start finally.
Tried to do Gps calibration and the lights blinking as show in video but not green with front both solid red...
Thanks @J Dot for your guide all the way.
Never crash before.
GPS mod value : 891.XX something
Will give it another try with anti static compass cover back.
Let you know soon. :D
I did all of the above.
When i try to start propeller motor it turn blinking red like below.
PS: gps calibration still failed and blinking like the first video i posted. ;(
Finally solved anti static compass err.
It's actually just loose cable on it.
Unpluged and plug in it and it's solved.
But when i try to do calibration in GPS mode and result with this blinking light. Propeller motor arm can't start up.
Any idea ???? Arggh [emoji31][emoji31]
My phantom 2 Vision + earlier time fail to calibrate for GPS calibration.
Few weeks then it in solid red light and motor will not start after firmware upgrade.
I did a hard reset for it and the problem still there.
Compass Err shows when connected. MOD value 0.
is it compass cause it ?
anyway...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.