I have spend the past 3 days debating which 3D printer to go with and have it narrowed down to 4
creator pro, taz 5, ultimately 2 or makerbot m2.. Has anyone used any of them?
I swapped the driver for the motor attached to the camera.
Now it stabilizes ish but the motors are making noise while doing so and the app thinks the gimbal is obstructed
I checked Both pots. No nicks or dents
Bottom yaw arm is screwed into the flat side
And tight
Camera was screwed into the rounded side of arm
I made sure pot of the yaw arm had the flat spot level What else am I missing?
It was doing the same thing before so I swapped the camera...
I hair replaced the flex cable on a p2 v+ and the gimbals jerks around and twitches like crazy.
I watched a YouTube video about making sure the flat spot on the horizon cable is facing down (with drone upside down)
In the app it says to remove the gimbal guard
What else would make the...
Yea the camwra/gimbal works fine aside from the bent arm.
3D printed one would be sweet. Do you have a 3D scan or model of the yaw arm to print? How much would you want for one?
So you thermal paste the chip to the housing and the heatsink to the wifi casing. I guess it all adds up! Looks like you left the heatsink pads inside as well? Would it work better to connect it directly to the cover?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.