Hi Dronesky,
Yes - I can confirm the manual binding method works; I have personally done it a few times since I was having problems getting any mobile device to work with my controller. The instructions that I followed seem to match Osos tip.
1. Turn on RC Tx.
2. Press and hold C1 + C2 +...
FYI, I ended up picking up a HDMI Module and that worked on both the GL300A and the GL300C. Odd that an update makes the regular modules stop working. Once I was able to connect via the app, I tried rolling back the firmware to see if the USB modules would communicate again and still no change...
I am hesitant to believe that it is a bad mainboard on two controllers, both of which control and fly the phantom fine but only stopped communicating with handheld devices after an update.
New to the phantoms (had been using Nazas before on some flamewheels and previously many other...
I am looking for an HDMI board as my next step. Hopefully I can find one in Southern California!
This could certainly be the case of a bad USB board even though I tried the USB module from the GL300C. In other news, I was able to manually bind the GL300C but its status is flashing green.
Thanks for the tips guys, swapped it over and still no connecting to DJI Go; tried these steps:
Controller reset ( both C1 + C2 as well as record , also tried adding in pressing the ISO wheel as some instructions show to do).
Reinstalled DJI GO on iPhone.
Installed DJI GO on Samsung G4.
Wiped...
I am curious, would swapping USB Board between GL300A and GL300C work?
Have a GL300A for my P3 Pro that I beleive has a bad USB interface and a GL300C on my bench that came with bad P4 purchase that also seems to have issues. Im wondering if I can salvage the USB board from the newer unit...
Thanks,
That was still a helpful reply :) You mentioned P3P, is the P3 4k and the P3P the same in the gimbal area? Could I use a P3P gimball & camera if I found on on ebay?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.