I did have the tablet connected to a Phantom 3 Standard, but I nuked DJI Go an installed DJI Go 4. I didn't reinstall Litchi - should I?
On the Samsung Tab A, it doesn't give you the option of just once or always for some reason, but you can go and clear defaults in app manager. The problem is...
Ok, I've seen a few threads here, but none have helped yet.
Just picked up a P4 and I'm trying to connect my Samsung Tab A to the drone. So far, the only thing that works is to plug in the USB and reboot the device, at which point it automatically loads DJI Go.
There's no other method that...
Oh ok, yup I've had that enabled for a while, and I've made sure it's not in beginner mode either. I've been able to run flight modes in the go app, so I'm at a loss. I think my only option is to email litchi support, which I've done.
So once I've loaded the mission it should load to the drone...
Yes, that's what I'm Don amc hoping will happen. However, I never saw anything in the limited litchi instructions on enabling multiple missions in the go app. How can I do that?
Yup, I do get the preflight report window and after I press go on that, I don't get any other visual feedback.
So if I've got it in F_GPS mode and is in auto takeep off it'll launch itself, right?
So to clarify, you see a window showing the status as it loads to the drone? If so, I never see that. I can load the mission from the device once it's sync'ed the missions from the Litchi hub and it loads near instantly.
How do you guys launch from the ground? I tried that as well and no dice. I put it in F_GPS and made sure auto takeoff was enabled.
BTW, ow long does it take the app to send the data to the drone? I waited forever, then finally landed it and turned it off. After about a minute, I got a voice...
I'm not sure what you mean. There's a load and save icon where you can load missions and save them, and then a play icon where you can start the mission.
Yeah, he's way out in the sticks, but we're picking up 10-14 satellites.
Is there any way to save the waypoints and load them into the DJO Go app as a waypoint mission?
I'm creating the missions on the litchi hub web app. I do click the upload icon and the modal window pops up in the app to select the mission and I see it load and overlay on the map. That's when I hit the play button, get the confirmation and then hit the "GO" button. It's at that point that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.