I’m sure most of us have seen the YouTube video of the guy spray painting his case.
Has anyone seen the results ?
I bought the paint but have been hesitant to try it for fear it will destroy it.
I don’t think he’s posted anything about how it turned out to my knowledge.
I have found a...
Not sure but check the wire connections inside the landing gear to be sure all the wires are connected securely.
If they are then you may need to crack it open and make sure all connections inside are solid as well.
Good luck
For safety reasons it might be best to test them in a kiddie pool were the water isn’t deep enough to actually loose your drone if they should fail.
Please do a video of the testing.
P.S. You did a really nice job designing them.
Waiting to see them on the market.
Is the battery in the RC a LiPo ?
Is it replaceable?
Does it require the same maintenance procedure as the intelligent batteries ?
I haven’t seen any information about the RC battery and was wondering if I should be doing anything special with it.....
I think Ive figured it out ....
It seems to only show up when I’m near metal objects
IE : taking off from my aluminum table on the deck
Didn’t think aluminum would matter since it’s not magnetic
I was wrong
Went out to a nearby flying field and had no problems at all other than...
I’ve had this warning come up a few times and I’m not sure what it means.
It’s only there for a second then gone. It does show in the warnings menu.
Can anyone give any info ?
Ok Ive found the file but my laptop doesn’t like the period at the beginning
Said it’s reserved for system files
Any ideas as to how I can fix this problem
I’ve installed it into Go 4 through iTunes without the period but it doesn’t work without it or I’m putting it in the wrong place inside Go 4
I’ve been trying to find the file to download for iOS
Everything I’ve come up with so far is junk
Anyone have a link that works with a P4
I’m using an iPad and it doesn’t like the . In the file name
Help !!!
I used the alcohol wipes then a dry paper towel.
After the label is attached, cut a strip of clear packaging tape slightly larger than the label itself and apply it over the sticker. If not my first label was gone after my first flight in cold weather.
I cracked her open today and found
the ribbon cable from the Flight Control board to the ESC board had come out of its plug at the ESC
I reinstalled it and all is back to normal. (After complete recalibration)
Apparently when I replaced the shell it was not in place completely
because the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.