Im trying to use the new flight modes ex. follow me waypoint etc but Im not able to locate them in app.. When I hit the P mode to change to F nothing changes. have P3S for about 3 weeks. Haven't done any updates but its telling me I need to do update for cold weather issue. Any help gretly...
This actually resolved my issue. Then I just had to calibrate x1 to face forward. Thank for your help
If you, for any reason, messed up with your Phantom V1.1 (dual antenna receiver) transmitter and installed the 5.4G firmware instead of 2.4G firmware you can restore it by doing this:
1.-...
Recently had an issue where i could not get P1 with h3-2d to face forward and P1 motors would not turn on. I was able to get resolved but when i went to fly it the motors do not start immediately like before. I have to mess with sticks even hold them down for few seconds. Second issue is quad...
Thank You for the response. I am not powering up the Phantom anywhere new. I am in my kitchen near my router and cordless home phone. Oddly this is the only spot in my home where the naza assistant will recognize the quad. I haven't made any new changes. I did switch out to fresh batteries. I...
I have Phantom 1 with H3-2D gimbal with DJ6 2.4 HZ TX. I turned on the tx then the Phantom and the camera immediately pointed down. It would only point straight when I turned off tx. I connected tx to pc and ran the RC ASSISTANT. I downloaded the latest firmware 1.0.2.26 and now when I turn on...
Hello. I have a DJI Phantom 1 tx version dj6 2.4ghz. I stripped the pot inside while trying to calibrate the x1 lever. Does anyone know where I can buy a replacement pot. Would hate to have to buy a whole new tx...Thanks!
Hello Guys,,,I was trying to get the tilt lever on back of P1 remote to work as i never used it.. Software assitant did not show any movement when i was trying to calibrate and turn the screw back and forth and now my h3-2d gimbal powers up but immediately faces downward.. It only faces forward...
So im wanting to get my first fpv system..I have a phantom 1 with h3-2d with gopro 3+..I am not interested in range as much as getting very good feed..I am leaning towards a Black Pearl 7 CH Diversity monitor/ a immersion 5.8ghz 600w transmitter/ the 3 antennna fplvr kit..What else will i need...
I never had a problem taking off. Didnt use Phantom in 3 weeks..Now it tilts foward on takeoff..I have only h3-2d and gopro on it..Made sure props were secure..Did the calibration dance..Did advance calibrations...Mods are averaging 1400..Verified i have 6 satelittes...Swapped with new dji...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.